The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Rub Rails

2019-02-08; 17:21:08 EST

Member Since

2005-04-29

Posts: 805

I installed the Tessilmare rub rail system on my boat. Picture attached. You
will see slight bulges in the rail where the plastic track spread from the
screws. If I were to do it again I would pay careful attention to not
seating the screws beyond the minimum that is necessary. They don't mention
this issue in the installation instructions and so I didn't realize the
problem I was creating until it was too late 
The rail gives very good protection. Installation needs to be done on a hot
day so the vinyl is soft and pliable. I was able to do it alone but it was a
struggle.
Graham

Graham Stewart
Agile 1976 Rhodes 22
Kingston Ontario

 


Reb rail installed- Tessilmare July 2016.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting