I was unable to "fish" through the space above the ceiling.  My forward
cabin light was located below the mast.  I was able to push wires from the
mast socket into the area of the cabin light and then routed them along the
ceiling to the bulkhead by the head.  From there I routed the wires under
the trim moldings to the area behind the galley and off to the circuit
distribution panel.

Mike
s/v Wind Lass ('91)
Nissequogue River, NY

-----Original Message-----
From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of
Lowe, Rob
Sent: Wednesday, May 9, 2018 10:09 AM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Running wire from mast to electrical panel

I'm replacing the wiring in my mast to a five wire cable so I can wire my
anchor and masthead light to operate independently (the two wire system
installed did not allow for that).   Does anyone know how to get the wire
from the plug on the cabin top to the electrical panel?  In other words, how
do you run or fish a wire between the cabin liner and the cabin top?  Thanks
for any help. - rob


__________________________________________________
To subscribe/unsubscribe go to
http://www.rhodes22.org/mailman/listinfo/rhodes22-list

For the list Charter and help with using the mailing list and archives go to
http://www.rhodes22.org/list
__________________________________________________