The Rhodes 22 Discussion Group
< prior
Back to Month
Go to Thread
Ric Stott
CB pendant length
2017-08-16; 12:36:47 EDT
Member Since
2013-07-01
Posts: 431
Hi Graham My blocks were not new but they were in good condition and free wheelin' Next time I'm out I'll have a look with a mask. It was never easy to retract the CB - always a tug. Sent from my iPhoneSee the original archive post
> On Aug 15, 2017, at 7:59 PM, Graham Stewart <gstewart8 at cogeco.ca> wrote: > > Ric: > My centre board was difficult to lift as well until I took the cap off and discovered that all of the blocks were seized up. I think some earlier owner used a sealant that squeezed into the housing and fouled up the blocks. New blocks made a world of difference. > > Graham > > -----Original Message----- > From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Richard Stott > Sent: August 15, 2017 9:32 AM > To: The Rhodes 22 Email List > Subject: Re: [Rhodes22-list] CB pendant length > > Graham > I stuck with the original design too. I can tell you that the system I have is too difficult for my wife to lift. In fact its not so easy for me either. > I know that its running free and clear, but its still a heavy lift, especially the last 6 inches. The diamond Board is most likely a solution to that issue; another upgrade that General Boats might offer someday. > I agree that a long line at the end of the CB is not a good solution. If the CB cap was not such a big deal to remove and replace, I would experiment, but for now, as with other minor annoyances, I sail the boat as much as possible and enjoy it immensely. > ric > sv Dadventure > > > >> On Aug 14, 2017, at 7:13 PM, Graham Stewart <gstewart8 at cogeco.ca> wrote: >> >> It wasn't high science but I experimented with not using the blocks when my boat was in it's lift. The board is heavier when in a lift than when in the water but even so it was a heavy lift - certainly more than my wife could lift or I would care to lift. My board weighs 80 pounds and most of that weight appears to be at the end where you would expect it to be. The attachment point for the line is about 1/3 of the way along the back edge. I figure that using that point of attachment would double the force needed to lift the board. That makes the board very heavy if you only use the one block and use the existing attachment point. >> >> The alternative might be to move the attachment point to the end of the board but that would mean it was dragging down low and aside from the friction and turbulence that would create, it would be very vulnerable to getting caught in weeds. Even then you are lifting about 35 pounds. I decided to stick with the original design. >> >> >> Graham Stewart >> Agile. R22, 1976 >> Kingston Ontario Canada >> >> >> >> >> -----Original Message----- >> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Richard Stott >> Sent: August 14, 2017 3:34 PM >> To: The Rhodes 22 Email List >> Subject: Re: [Rhodes22-list] CB pendant length >> >> I was thinking of no blocks. Has anyone changed their old school set up to omit the blocks? >> Does the Diamond Board have any blocks? >> thanks >> ric >> sv Dadventure >> Hampton Bays >> >> >> >>> On Aug 14, 2017, at 3:23 PM, Richard Beytagh <rbeytagh at gmail.com> wrote: >>> >>> I have the same set up on Waif - 1984 hull - and I am going through >>> the possess of rebuilding my center-board cap. Long story, but the >>> board came down when I was launching -'nuff said. >>> >>> I too have 2 blocks and I think I will leave them as is - Stan in his >>> infinite wisdom spec'ed it this way. I suspect you could get away with >>> one block if you choose to go this route. >>> >>> >>> >>> <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&u >>> tm_campaign=sig-email&utm_content=webmail> >>> Virus-free. >>> www.avg.com >>> <http://www.avg.com/email-signature?utm_medium=email&utm_source=link&u >>> tm_campaign=sig-email&utm_content=webmail> >>> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> >>> >>> >>> >>> ~~~ _/) ~~~ >>> >>> Richard Beytagh >>> Phone: 828 337 0180 >>> >>> On Mon, Aug 14, 2017 at 1:57 PM, Richard Stott >>> <ric at stottarchitecture.com> >>> wrote: >>> >>>> I have an old style board. Its not that heavy, I’ve opened the >>>> gasketed top cap, removed the CB and repaired the cap, which was >>>> cracked due to a grounding. I refurbished the trunk and replaced the >>>> hose parts which occupy the slots, installed to prevent the board >>>> from sliding up in its tracks and hitting the cap - which is >>>> apparently what happened. Anyway - the board is not that heavy and >>>> although I replaced the line and blocks, I questioned myself at the >>>> time, that all that purchase adds more friction than the weight it presumably helps to lift. >>>> It sounds like the newer diamond board does not use any blocks and is >>>> a direct path from the back of the board with no turning blocks. >>>> Ric >>>> sv Dadventure >>>> >>>> >>>> >>>> >>>> >>>> >>>>> On Aug 14, 2017, at 1:25 PM, Richard Beytagh <rbeytagh at gmail.com> wrote: >>>>> >>>>> Can I suggest that you reeve the pennant with plenty to spare and >>>>> when >>>> you >>>>> have the boat in the water and can test it, you cut it length...just >>>>> a suggestion >>>>> >>>>> <http://www.avg.com/email-signature?utm_medium=email& >>>> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>>>> Virus-free. >>>>> www.avg.com >>>>> <http://www.avg.com/email-signature?utm_medium=email& >>>> utm_source=link&utm_campaign=sig-email&utm_content=webmail> >>>>> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2> >>>>> >>>>> >>>>> >>>>> ~~~ _/) ~~~ >>>>> >>>>> Richard Beytagh >>>>> Phone: 828 337 0180 >>>>> >>>>> On Mon, Aug 14, 2017 at 12:55 PM, Graham Stewart >>>>> <gstewart8 at cogeco.ca> >>>>> wrote: >>>>> >>>>>> Jay: >>>>>> I had misunderstood your original message. >>>>>> >>>>>> I just measured my tether. With the board up I have 68" of line showing. >>>>>> With board down all but a few inches are used. >>>>>> >>>>>> My boat does not have the diamond board - if that makes a difference. >>>>>> >>>>>> >>>>>> Graham Stewart >>>>>> Agile. R22, 1976 >>>>>> Kingston Ontario Canada >>>>>> >>>>>> >>>>>> >>>>>> >>>>>> -----Original Message----- >>>>>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On >>>> Behalf >>>>>> Of Jay Friedland >>>>>> Sent: August 13, 2017 10:46 PM >>>>>> To: The Rhodes 22 Email List >>>>>> Subject: Re: [Rhodes22-list] CB pendant length >>>>>> >>>>>> Thanlks, Graham. >>>>>> >>>>>> I had some big differences over what you have. My first 1986 R22 >>>>>> had the original CB, and I added a single block. It went through at >>>>>> least >>>> 18-20” of >>>>>> travel. This new factory-replaced CB pulls fully down over the 38” >>>> length. >>>>>> I just don’t know where the sweet spot or usable depth is hit. >>>>>> >>>>>> Jay >>>>>> >>>>>> >>>>>>> On Aug 13, 2017, at 8:26 PM, Graham Stewart <gstewart8 at cogeco.ca> >>>> wrote: >>>>>>> >>>>>>> Jay: >>>>>>> The line that raises my centreboard is about 12'. It has to pass >>>> through >>>>>> three blocks before the final block at the base of the tube leading >>>>>> to >>>> the >>>>>> cockpit. When the centerboard is down I have very little line that >>>>>> is >>>> free. >>>>>> I have the original centreboard but I think the line route s the >>>>>> same >>>> for >>>>>> the diamond board. >>>>>>> >>>>>>> Graham Stewart >>>>>>> Agile. R22, 1976 >>>>>>> Kingston Ontario Canada >>>>>>> >>>>>>> >>>>>>> >>>>>>> -----Original Message----- >>>>>>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On >>>>>>> Behalf Of Jay Friedland >>>>>>> Sent: August 13, 2017 12:11 PM >>>>>>> To: The Rhodes 22 Email List >>>>>>> Subject: [Rhodes22-list] CB pendant length >>>>>>> >>>>>>> Wondering about the optimum length for best use of the diamond >>>>>>> board. I >>>>>> have 38” (full travel, stopper knot to exit hole) but have measured >>>>>> everywhere from 26” on up. Most have been factory set. >>>>>>> >>>>>>> Jay Friedland >>>>>>> s/v Wanderlust ‘97 >>>>>>> __________________________________________________ >>>>>>> To subscribe/unsubscribe go to >>>>>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>>>>> >>>>>>> For the list Charter and help with using the mailing list and >>>>>>> archives go to http://www.rhodes22.org/list >>>>>>> __________________________________________________ >>>>>>> >>>>>>> __________________________________________________ >>>>>>> To subscribe/unsubscribe go to >>>>>>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>>>>>> >>>>>>> For the list Charter and help with using the mailing list and >>>>>>> archives go to http://www.rhodes22.org/list >>>>>>> __________________________________________________ >>>>>> >>>>>> __________________________________________________ >>>>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>>>> mailman/listinfo/rhodes22-list >>>>>> >>>>>> For the list Charter and help with using the mailing list and >>>>>> archives >>>> go >>>>>> to http://www.rhodes22.org/list ______________________________ >>>>>> ____________________ >>>>>> >>>>>> __________________________________________________ >>>>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>>>> mailman/listinfo/rhodes22-list >>>>>> >>>>>> For the list Charter and help with using the mailing list and >>>>>> archives >>>> go >>>>>> to http://www.rhodes22.org/list >>>>>> __________________________________________________ >>>>>> >>>>> __________________________________________________ >>>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>> mailman/listinfo/rhodes22-list >>>>> >>>>> For the list Charter and help with using the mailing list and >>>>> archives >>>> go to http://www.rhodes22.org/list >>>>> __________________________________________________ >>>> >>>> >>>> >>>> Richard F. Stott, AIA, LEED AP >>>> ric at stottarchitecture.com >>>> o- 631-283-1777 >>>> c- 516-965-3164 >>>> >>>> >>>> >>>> >>>> __________________________________________________ >>>> To subscribe/unsubscribe go to http://www.rhodes22.org/ >>>> mailman/listinfo/rhodes22-list >>>> >>>> For the list Charter and help with using the mailing list and >>>> archives go to http://www.rhodes22.org/list >>>> __________________________________________________ >>>> >>> __________________________________________________ >>> To subscribe/unsubscribe go to >>> http://www.rhodes22.org/mailman/listinfo/rhodes22-list >>> >>> For the list Charter and help with using the mailing list and archives >>> go to http://www.rhodes22.org/list >>> __________________________________________________ >> >> >> >> Richard F. Stott, AIA, LEED AP >> ric at stottarchitecture.com >> o- 631-283-1777 >> c- 516-965-3164 >> >> >> >> >> __________________________________________________ >> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list >> __________________________________________________ >> >> __________________________________________________ >> To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list >> >> For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list >> __________________________________________________ > > > > Richard F. Stott, AIA, LEED AP > ric at stottarchitecture.com > o- 631-283-1777 > c- 516-965-3164 > > > > > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________ > > __________________________________________________ > To subscribe/unsubscribe go to http://www.rhodes22.org/mailman/listinfo/rhodes22-list > > For the list Charter and help with using the mailing list and archives go to http://www.rhodes22.org/list > __________________________________________________
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form, .
Post to the Rhodes 22 Email List:
Sending Post:
Your post is being sent... 