Can I suggest that you reeve the pennant with plenty to spare and when you
have the boat in the water and can test it, you cut it length...just a
suggestion

<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
Virus-free.
www.avg.com
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>



~~~ _/) ~~~

Richard Beytagh
Phone: 828 337 0180

On Mon, Aug 14, 2017 at 12:55 PM, Graham Stewart <gstewart8 at cogeco.ca>
wrote:

> Jay:
> I had misunderstood your original message.
>
> I just measured my tether. With the board up I have 68" of line showing.
> With board down all but a few inches are used.
>
> My boat does not have the diamond board - if that makes a difference.
>
>
> Graham Stewart
> Agile. R22, 1976
> Kingston Ontario Canada
>
>
>
>
> -----Original Message-----
> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf
> Of Jay Friedland
> Sent: August 13, 2017 10:46 PM
> To: The Rhodes 22 Email List
> Subject: Re: [Rhodes22-list] CB pendant length
>
> Thanlks, Graham.
>
> I had some big differences over what you have. My first 1986 R22 had the
> original CB, and I added a single block. It went through at least 18-20” of
> travel. This new factory-replaced CB  pulls fully down over the 38” length.
> I just don’t know where the sweet spot or usable depth is hit.
>
> Jay
>
>
> > On Aug 13, 2017, at 8:26 PM, Graham Stewart <gstewart8 at cogeco.ca> wrote:
> >
> > Jay:
> > The line that raises my centreboard is about 12'. It has to pass through
> three blocks before the final block at the base of the tube leading to the
> cockpit. When the centerboard is down I have very little line that is free.
> I have the original centreboard but I think the line route s the same for
> the diamond board.
> >
> > Graham Stewart
> > Agile. R22, 1976
> > Kingston Ontario Canada
> >
> >
> >
> > -----Original Message-----
> > From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On
> > Behalf Of Jay Friedland
> > Sent: August 13, 2017 12:11 PM
> > To: The Rhodes 22 Email List
> > Subject: [Rhodes22-list] CB pendant length
> >
> > Wondering about the optimum length for best use of the diamond board. I
> have 38” (full travel, stopper knot to exit hole) but have measured
> everywhere from 26” on up. Most have been factory set.
> >
> > Jay Friedland
> > s/v Wanderlust ‘97
> > __________________________________________________
> > To subscribe/unsubscribe go to
> > http://www.rhodes22.org/mailman/listinfo/rhodes22-list
> >
> > For the list Charter and help with using the mailing list and archives
> > go to http://www.rhodes22.org/list
> > __________________________________________________
> >
> > __________________________________________________
> > To subscribe/unsubscribe go to
> > http://www.rhodes22.org/mailman/listinfo/rhodes22-list
> >
> > For the list Charter and help with using the mailing list and archives
> > go to http://www.rhodes22.org/list
> > __________________________________________________
>
> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/
> mailman/listinfo/rhodes22-list
>
> For the list Charter and help with using the mailing list and archives go
> to http://www.rhodes22.org/list ______________________________
> ____________________
>
> __________________________________________________
> To subscribe/unsubscribe go to http://www.rhodes22.org/
> mailman/listinfo/rhodes22-list
>
> For the list Charter and help with using the mailing list and archives go
> to http://www.rhodes22.org/list
> __________________________________________________
>