Mike,
Unable to get a read on oil consumption as it has not been run since I changed it other than these short starts for a few minutes.  Still full and golden.  It does not appear to have an air filter.  Oil was dripping from carb. intake side.  Some smoke would have to come from oil being sucked through the card so I am very hopeful it is PVC.  I can't find much useful info. in the manual so I'll just have to troubleshoot by hunting for clogged tubes.
Thanks for giving me some hope.
Patrick

On Tue, Apr 2, 2024 at 2:12 PM Michael D. Weisner <mweisner at ebsmed.com>
wrote:

> Patrick,
>
> I think that if you have a problem with "stuck" piston rings, you would
> know it. I would suspect that there would be a loud noise and the engine
> probably would not run at low speeds as it seized up.
>
> My guess is more a problem with the crankcase ventilation system. Usually
> there is a PCV style one-way valve that sucks oil fumes out of the
> crankcase, burning them by introducing into the air intake. Check the air
> filter which is usually part of the recirculation circuit as it can become
> saturated with oil.
>
> Is the engine consuming oil? Have you checked the oil level using the
> dipstick? The smoke and excess oil can be the result of worn (not stuck)
> piston rings or valves that are allowing the oil to pass into the
> combustion path.
>
> Mike
> s/v Wind Lass ('91)
> Nissequogue River, NY
> I’d rather be sailing :~)
>
> -----Original Message-----
> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of PBR
> Sent: Tuesday, April 2, 2024 1:52 PM
> To: rhodes22-list at rhodes22.org
> Subject: [Rhodes22-list] Honda BF9.9 Oil from carb
>
> Hello all.
>
> I have a Honda 9.9 2 cyl.  that has been mostly sitting for a few years.
> It sat on the boat in Kitty Hawk (humid environment) for one winter
> untouched (2018).  Since then I have not used it on the water but always
> expecting that I might anytime soon I did not winterize but dutifully
> started it every couple of months throughout the winters and ran it a bit
> with the water hose.  Always started easy and ran good.  Some smoke at
> first but not enough to concern me.  This time as I was about to put the
> thing in to use I put a bucket (trash can ) around it and ran it again.
> Started easy , runs good, again some smoking, enough to get me curious but
> not constant at all speeds.
>
> Looking under the cowling I see oil dripping from the carb intake (clean
> golden oil).  Still running fine.I am hoping there may be a *vent clog* or
> something rather than just frozen rings.  Any thoughts?  *Stuck valve?* (
> but runs pretty good)
>
> This 1999 motor has VERY VERY low miles and looks brand new so I hate to
> scrap it but given the date of manufacture the value is probably less than
> a marine repair will charge me to take a look.  Hoping for a miracle
> solution.  Twice I have removed mud dauber bee nests from under the cowling
> so maybe I can find something suspicous.
>
> The trash can I ran it in did have some residual oil clinging to the sides
> but I don't know how much might be normal.
>
> My plan next trip in a couple of weeks is to look for clogs and try
> running again maybe with a high dose of sea foam or something.  Not sure of
> any miracle sauce that might help stuck rings.
>
> Patrick
>
>