Amazon.com has the Fulton XP10 0101 Swivel Trailer Tongue Jack, 1200 Lbs. Capacity for $83.54

Just look up "Fulton Swivel Trailer Jack" on Amazon for quite a selection.

Harbor Freight has the "Haul-Master" line for a bit less. I've been happy with the Haul-Master 1500 lbs Dual Wheel for the trailer tongue.

I added two more to the rear of the trailer to prevent my single axle from moving (down) when not hooked to the tow vehicle as I climb up the stern ladder. Only one is actually needed but I have lifted the tires off the ground with these jacks. I then place blocks under the axle near the wheels and release some of the pressure on the jacks. I wanted to get a heavier duty jack for the rear but they require a welded fitting, not just a bolt on. Be sure to get swing away jacks otherwise they may interfere with recovery in shallow water.

Mike
s/v Wind Lass ('91)
Nissequogue River, NY
I’d rather be sailing :~)

-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of Jay Friedland
Sent: Wednesday, November 22, 2023 7:01 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Triad Trailer Jack replacement

After 12 years or so, my Fulton trailer jack on my (Stan supplied) Triad trailer froze up. If the boat’s average weight is approximately 4,000 lbs., the tongue weight maybe on the high side at 500 lbs., I’ve looked at ratings at 1,000 to 1,200 lbs., overbuilt, but I rely on it often. I liked the Fulton unit but can’t identify it or also looking at the Reese Towpower 74410. Any help on this or a good replacement is appreciated.

Jay Friedland
S/V Wanderlust ’97