Take the pins out and put one of them through the hole near the other end.
Use a short length of chain to make some sort of loop connection to it. Use
either a come-along or block and tackle between that and the winch post.
Mine was stuck solid and a 6:1 block and tackle moved it easily.

On Thu, May 13, 2021 at 6:19 AM ROGER PIHLAJA <roger_pihlaja at msn.com> wrote:

> Jim,
>
> I would expect the wheels on the tow vehicle to slip before the trailer
> axle would move or break!  The other suggestions about soaking in rust
> buster overnight, banging with a hammer, etc are good.  If ever got the
> tongue extension loose; then, I would find a way to flush the loose rust
> out of the channel while it’s extended.  Then, I would scrape and paint the
> tongue extension with Rust-O-Leum and run a rag soaked in gun oil thru the
> channel to stop the future rust.
>
> Roger Pihlaja
> S/V Dynamic Equilibrium
>
> Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for
> Windows 10
>
> From: ROGER PIHLAJA<mailto:roger_pihlaja at msn.com>
> Sent: Wednesday, May 12, 2021 3:09 PM
> To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
> Subject: Re: [Rhodes22-list] Trailer Extension Replacement
>
> Jim,
>
> I’m wondering what would happen if you blocked the trailer’s wheels so
> they couldn’t move and then pulled on the hitch extension with your tow
> vehicle.  This seems like the maximum amount of force you could apply at
> home.  You could even try repeatedly backing up and going forward several
> times.  If that doesn’t break the rust loose, I don’t know what else to
> suggest.
>
> Roger Pihlaja
> S/V Dynamic Equilibrium
>
> Sent from my iPhone
>
> > On May 12, 2021, at 11:25 AM, Michael D. Weisner <mweisner at ebsmed.com>
> wrote:
> >
> > ?Hi Jim,
> >
> > If you need any physical help, just ask. I'm in Kings Park, a few miles
> down
> > the road.
> >
> > Mike
> > s/v Windlass ('91)
> > Nissequogue River, NY
> >
> > -----Original Message-----
> > From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of
> > JimIggy
> > Sent: Monday, May 10, 2021 12:43 AM
> > To: rhodes22-list at rhodes22.org
> > Subject: Re: [Rhodes22-list] Trailer Extension Replacement
> >
> > I'm wondering if I can hijack this thread to ask a question about the
> > trailer extension.  I can start a new one if necessary.
> >
> > I recently acquired a Rhodes 22 w-trailer.  According to the previous
> owner,
> > the boat/trailer has been sitting for about 10 years.   I removed the two
> > pins, but the extension will not move.  I tried pulling the trailer with
> the
> > pins removed and the extension is still stuck in place.  There is
> definitely
> > rust where the extension passes through the receiver.  I used numerous
> > sprays, and a 5lb mallet in an effort to free it up.  No luck thus far.
> I'm
> > considering using heat or perhaps an air hammer.   The extension would be
> > very helpful given where I want to launch.
> >
> > Has anyone dealt with this ?   Should I start a new thread ?   Thank you
> >
> > 1988 Rhodes 22
> > Port Jefferson NY
> >
> >
> >
> >
> >
> > --
> > Sent from: http://rhodes-22.1065344.n5.nabble.com/
> >
>
>