Love love love my Raymarine autotiller. 
Could not do what I do without it. 
Ric 
sv Dadventure

Sent from my iPhone

> On Feb 18, 2021, at 5:30 PM, Peter Nyberg <peter at sunnybeeches.com> wrote:
> 
> ?I have the Raymarine ST1000.  Actually, I depend on it so heavily, that I have two.  I have had one stop working.  I sent it back to Raymarine and they fixed it a no cost.
> 
> Attached is a document created by Bill Wickman about his installation of the ST1000.  I followed this pretty closely.  However, at the point where the tiller pilot attaches to the cockpit combing, he said he found the fiberglass to be thick, and needed no reinforcement.  I found the fiberglass to be quite thin at the point, and epoxied in a block of 3/4” thick hardwood.
> 
> I have no experience with the Simrad.
> 
> Good luck with your project.
> 
> Peter Nyberg
> Coventry, CT
> s/v Silverheels (1988/2016)
> -------------- next part --------------
> A non-text attachment was scrubbed...
> Name: TillerPilotSetuponRhodes22.pdf
> Type: application/pdf
> Size: 786461 bytes
> Desc: not available
> URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20210218/fdaa4e04/attachment.pdf>
> -------------- next part --------------
> 
> 
> 
>> On Feb 18, 2021, at 5:13 PM, MichaelM <mm.bizlist1 at gmail.com> wrote:
>> 
>> I'm hoping to install a Raymarine or Simrad tiller pilot in my boat.
>> 
>> Can you share your experience with either unit and what challenges if any
>> did you encountered during the installation?
>> 
>> Thanks!
>> 
>> Mike McKay
>> s/v Liber 2006/2018
>> 
>> 
>> 
>> --
>> Sent from: http://rhodes-22.1065344.n5.nabble.com/
>