Hi Reuben,Congratulations on finally getting your Rhodes.  I would have enjoyed the test sail with you last year...but COVID-19 got in the way.  I think you will enjoy the different finesse involved with sailing the Rhodes.  
All the best,Don Simons,
Ithaca, NY

Sent from Yahoo Mail on Android 
 
  On Wed, Jan 13, 2021 at 10:19 AM, Reuben Mezrich<reuben.mezrich at gmail.com> wrote:   Jesse
Yes, I"ve had it out for a few sails but I'm still learning...its a big
change from my Island Packet 380 but I know I'm going to enjoy it.

Regarding the panel..its not mine..I was responding to a previous email in
which the author had described his rewiring of the panel...he doesn't give
his name so I can't tell you who it is. It was posted back in June...I
agree its very nice work. Having the hinge makes access ever so much easier.
--Reuben
Reuben Mezrich
Pelican Cove in Sarasota
Cell: 410-499-8922

On Wed, Jan 13, 2021 at 9:12 AM Jesse Shumaker <
jesse.laten.shumaker at gmail.com> wrote:

> Rueben, congrats on getting your Rhodes 22!  From past posts to the list I
> know you were eagerly anticipating that for a while.  Have you taken it out
> for a first sail yet?
>
> That's a nice setup for the wiring enclosure.  Did the access panel in your
> photo come from the factory that way or did you fabricate and install
> that?
>
> I once tried pulling out the wiring panel on mine but everything was quite
> tight and it was hard to get access.  Next fall, I would like to tackle a
> project like this with installing a terminal block and similar access
> panel.  I just wasn't sure how much I would have to remove to
> accomplish this.
>
> For anyone that has been down this path, is it possible to remove just the
> top shelf of the galley without removing the base?
>
> Jesse Shumaker
> S/V Zephyr
>
> On Tue, Jan 12, 2021 at 8:18 PM Reuben Mezrich <reuben.mezrich at gmail.com>
> wrote:
>
> > Roger
> > Thanks.  I’ll try that
> > Reuben
> >
> > Reuben Mezrich
> > Cell: 410-499-8922
> >
> > > On Jan 12, 2021, at 8:18 PM, Thomas Polise via Rhodes22-list <
> > rhodes22-list at rhodes22.org> wrote:
> > >
> > > ?Yes, note wiring.
> > > -------------- next part --------------
> > > A non-text attachment was scrubbed...
> > > Name: 9d078d01-039a-4060-a38a-026c6cf0c1fb.jpg
> > > Type: image/jpeg
> > > Size: 564868 bytes
> > > Desc: not available
> > > URL: <
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20210112/526fc962/attachment.jpg
> > >
> > > -------------- next part --------------
> > >
> > >
> > >> On Jan 12, 2021, at 6:37 PM, Scott Andrews via Rhodes22-list <
> > rhodes22-list at rhodes22.org> wrote:
> > >>
> > >> ?I like that panel enclosure too. Is that outlet for shore power?
> > >> Scott, new owner
> > >>
> > >> Sent from my iPhone
> > >>
> > >>>> On Jan 12, 2021, at 5:54 PM, Reuben Mezrich <
> reuben.mezrich at gmail.com>
> > wrote:
> > >>>
> > >>> ?I?ve managed to run a messenger line from the lazerrete, under the
> > starboard seats and then into the cabin where it exits onto the cabin
> > floor. I?m wondering how to get it up to the panel (and then I?ll use the
> > messenger line to pull power lines)
> > >>>
> > >>> Reuben Mezrich
> > >>> Cell: 410-499-8922
> > >>>
> > >>>>> On Jan 12, 2021, at 4:47 PM, ROGER PIHLAJA <roger_pihlaja at msn.com>
> > wrote:
> > >>>>
> > >>>> ?Reuben,
> > >>>>
> > >>>> Look under the starboard cockpit seat, way up to the hull/deck
> > joint.  You should see at least one cable, which runs the stern running
> > light.  On my boat, this cable is secured to the hull/deck joint by small
> > retaining clamps and nylon cable ties.  You should be able to snip the
> > cable ties with a pair of side cutters, run the new wire, and then secure
> > the bundle to the same retaining clamps with new cable ties.  If you are
> a
> > big person, there isn?t much room under the cockpit seat, so you might
> want
> > to find a small assistant.  Good luck!
> > >>>>
> > >>>> Roger Pihlaja
> > >>>> S/V Dynamic Equilibrium
> > >>>>
> > >>>> Sent from my iPhone
> > >>>>
> > >>>>>> On Jan 12, 2021, at 4:09 PM, reuben.mezrich at gmail.com wrote:
> > >>>>>
> > >>>>> ?Hi
> > >>>>> I'm trying to run a wire from the panel to the lazerette. I"ve
> > managed to run a messenger line from the lazerette under the starboard
> > seats and then into the cabin. Would you remember how to run the line
> from
> > the cabin floor to the panel?
> > >>>>> Thanks in advance
> > >>>>> --Reuben
> > >>>>> <quote author='Rhodes 22 mailing list'>
> > >>>>>
> > >>>>> Regarding panel wiring.  I wound up re-routing all wires between
> the
> > cabin
> > >>>>> wall and cockpit wall and terminating  on a terminal block so that
> I
> > could
> > >>>>> have ready access to panel. I left some pull wires down to bilge so
> > I could
> > >>>>> run future wiring.  See attached photos.
> > >>>>>
> > >>>>> -------------- next part --------------
> > >>>>> A non-text attachment was scrubbed...
> > >>>>> Name: IMG_4141.jpg
> > >>>>> Type: image/jpeg
> > >>>>> Size: 23956 bytes
> > >>>>> Desc: not available
> > >>>>> URL:
> > >>>>> <
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200621/ce41e2d8/attachment.jpg
> > >
> > >>>>> -------------- next part --------------
> > >>>>>
> > >>>>>
> > >>>>>
> > >>>>> -------------- next part --------------
> > >>>>> A non-text attachment was scrubbed...
> > >>>>> Name: IMG_4143.jpg
> > >>>>> Type: image/jpeg
> > >>>>> Size: 31606 bytes
> > >>>>> Desc: not available
> > >>>>> URL:
> > >>>>> <
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200621/ce41e2d8/attachment-0001.jpg
> > >
> > >>>>>
> > >>>>> </quote>
> > >>>>> Quoted from:
> > >>>>> http://rhodes-22.1065344.n5.nabble.com/Panel-wiring-tp57483.html
> > >>>>>
> > >>>>>
> > >>>>> _____________________________________
> > >>>>> Sent from http://rhodes-22.1065344.n5.nabble.com
> > >>>>>
> > >>
> >
>