Jesse
Yes, I"ve had it out for a few sails but I'm still learning...its a big
change from my Island Packet 380 but I know I'm going to enjoy it.

Regarding the panel..its not mine..I was responding to a previous email in
which the author had described his rewiring of the panel...he doesn't give
his name so I can't tell you who it is. It was posted back in June...I
agree its very nice work. Having the hinge makes access ever so much easier.
--Reuben
Reuben Mezrich
Pelican Cove in Sarasota
Cell: 410-499-8922

On Wed, Jan 13, 2021 at 9:12 AM Jesse Shumaker <
jesse.laten.shumaker at gmail.com> wrote:

> Rueben, congrats on getting your Rhodes 22!  From past posts to the list I
> know you were eagerly anticipating that for a while.  Have you taken it out
> for a first sail yet?
>
> That's a nice setup for the wiring enclosure.  Did the access panel in your
> photo come from the factory that way or did you fabricate and install
> that?
>
> I once tried pulling out the wiring panel on mine but everything was quite
> tight and it was hard to get access.  Next fall, I would like to tackle a
> project like this with installing a terminal block and similar access
> panel.  I just wasn't sure how much I would have to remove to
> accomplish this.
>
> For anyone that has been down this path, is it possible to remove just the
> top shelf of the galley without removing the base?
>
> Jesse Shumaker
> S/V Zephyr
>
> On Tue, Jan 12, 2021 at 8:18 PM Reuben Mezrich <reuben.mezrich at gmail.com>
> wrote:
>
> > Roger
> > Thanks.  I’ll try that
> > Reuben
> >
> > Reuben Mezrich
> > Cell: 410-499-8922
> >
> > > On Jan 12, 2021, at 8:18 PM, Thomas Polise via Rhodes22-list <
> > rhodes22-list at rhodes22.org> wrote:
> > >
> > > ?Yes, note wiring.
> > > -------------- next part --------------
> > > A non-text attachment was scrubbed...
> > > Name: 9d078d01-039a-4060-a38a-026c6cf0c1fb.jpg
> > > Type: image/jpeg
> > > Size: 564868 bytes
> > > Desc: not available
> > > URL: <
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20210112/526fc962/attachment.jpg
> > >
> > > -------------- next part --------------
> > >
> > >
> > >> On Jan 12, 2021, at 6:37 PM, Scott Andrews via Rhodes22-list <
> > rhodes22-list at rhodes22.org> wrote:
> > >>
> > >> ?I like that panel enclosure too. Is that outlet for shore power?
> > >> Scott, new owner
> > >>
> > >> Sent from my iPhone
> > >>
> > >>>> On Jan 12, 2021, at 5:54 PM, Reuben Mezrich <
> reuben.mezrich at gmail.com>
> > wrote:
> > >>>
> > >>> ?I?ve managed to run a messenger line from the lazerrete, under the
> > starboard seats and then into the cabin where it exits onto the cabin
> > floor. I?m wondering how to get it up to the panel (and then I?ll use the
> > messenger line to pull power lines)
> > >>>
> > >>> Reuben Mezrich
> > >>> Cell: 410-499-8922
> > >>>
> > >>>>> On Jan 12, 2021, at 4:47 PM, ROGER PIHLAJA <roger_pihlaja at msn.com>
> > wrote:
> > >>>>
> > >>>> ?Reuben,
> > >>>>
> > >>>> Look under the starboard cockpit seat, way up to the hull/deck
> > joint.  You should see at least one cable, which runs the stern running
> > light.  On my boat, this cable is secured to the hull/deck joint by small
> > retaining clamps and nylon cable ties.  You should be able to snip the
> > cable ties with a pair of side cutters, run the new wire, and then secure
> > the bundle to the same retaining clamps with new cable ties.  If you are
> a
> > big person, there isn?t much room under the cockpit seat, so you might
> want
> > to find a small assistant.  Good luck!
> > >>>>
> > >>>> Roger Pihlaja
> > >>>> S/V Dynamic Equilibrium
> > >>>>
> > >>>> Sent from my iPhone
> > >>>>
> > >>>>>> On Jan 12, 2021, at 4:09 PM, reuben.mezrich at gmail.com wrote:
> > >>>>>
> > >>>>> ?Hi
> > >>>>> I'm trying to run a wire from the panel to the lazerette. I"ve
> > managed to run a messenger line from the lazerette under the starboard
> > seats and then into the cabin. Would you remember how to run the line
> from
> > the cabin floor to the panel?
> > >>>>> Thanks in advance
> > >>>>> --Reuben
> > >>>>> <quote author='Rhodes 22 mailing list'>
> > >>>>>
> > >>>>> Regarding panel wiring.  I wound up re-routing all wires between
> the
> > cabin
> > >>>>> wall and cockpit wall and terminating  on a terminal block so that
> I
> > could
> > >>>>> have ready access to panel. I left some pull wires down to bilge so
> > I could
> > >>>>> run future wiring.  See attached photos.
> > >>>>>
> > >>>>> -------------- next part --------------
> > >>>>> A non-text attachment was scrubbed...
> > >>>>> Name: IMG_4141.jpg
> > >>>>> Type: image/jpeg
> > >>>>> Size: 23956 bytes
> > >>>>> Desc: not available
> > >>>>> URL:
> > >>>>> <
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200621/ce41e2d8/attachment.jpg
> > >
> > >>>>> -------------- next part --------------
> > >>>>>
> > >>>>>
> > >>>>>
> > >>>>> -------------- next part --------------
> > >>>>> A non-text attachment was scrubbed...
> > >>>>> Name: IMG_4143.jpg
> > >>>>> Type: image/jpeg
> > >>>>> Size: 31606 bytes
> > >>>>> Desc: not available
> > >>>>> URL:
> > >>>>> <
> >
> http://rhodes22.org/pipermail/rhodes22-list/attachments/20200621/ce41e2d8/attachment-0001.jpg
> > >
> > >>>>>
> > >>>>> </quote>
> > >>>>> Quoted from:
> > >>>>> http://rhodes-22.1065344.n5.nabble.com/Panel-wiring-tp57483.html
> > >>>>>
> > >>>>>
> > >>>>> _____________________________________
> > >>>>> Sent from http://rhodes-22.1065344.n5.nabble.com
> > >>>>>
> > >>
> >
>