Mark:

Neat install. What did you use for a thru hull?

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario

-----Original Message-----
From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Mark Whipple
Sent: Thursday, August 13, 2020 9:22 AM
To: The Rhodes 22 Email List
Subject: Re: [Rhodes22-list] CB Pennant drain

Just in case you wanted to know the rest of the story:

Yesterday I finally got around to completing the replacement of drain on
the bridge deck that the centerboard pennant runs through. I have a 2000
Rhodes 22.

It took a little bit of experimentation but I found a 1 1/4" ID hose fits
the upper part of the drain and a 3/4" hose fits on the bottom. I got a 1
1/4" to 3/4" adapter to join the two. Add some hose clamps, remember to
thread the CB pennant through it all before installing, and then it's just
getting the lengths right so it can all go together but still be long
enough to be clamped. Attached is a couple pics of the finished product
along with the monstrosity I removed. What you don't see in the "before"
shot is the completely rusted hose clamps that I had to use a Dremel to
remove. The slit in the old hose is also from the removal process.

Mark
-- 
Boston, MA

2000 R22 *Luna Mia*
1987 Nimble 30 *For Sale*
1982 Com-Pac 16 *For Sale*

On Mon, Jun 15, 2020 at 8:10 PM Mark Whipple <mark at whipplefamily.com> wrote:

> Hi All,
>
> If this is in the archives somewhere let me know. I've done a little
> searching on Nabble and didn't find what I needed. I need to replace the
> hose that connects the drain the CB/diamondboard pennant runs through.
>
> It looks like the OD of the lower section (closer to the CB) is 7/8" OD.
> The top section where the pennant exits is about 1" ID, so I'm guessing
> it's about 1 1/4" OD. Total possible length looks to be about 10". The
> difference in diameters partially explains the abomination that I removed.
> Someone tried to mate two different hoses with clamps and lots of silicone.
>
> What has worked well for you in replacing this drain hose? I am wondering
> if I can get a hose that will fit the upper part of the drain, and then use
> a modified section of that same hose to bring the bottom fitting closer to
> 1 1/4". Then I'd put the larger hose over the smaller one, clamping the
> smaller section low and then the larger, overlapping hose as well.
>
> Thanks
> Mark Whipple
> Boston, MA
>
> 2000 R22 Luna Mia
> 1987 Nimble 30 (for sale)
> 1982 ComPac 16 (for sale)
>
>
>