Wow!  Nice job.  Thanks for sharing.  Joe Riley s/v Second Wind, Athens Ga

-----Original Message-----
From: Jesse Shumaker <jesse.laten.shumaker at gmail.com>
To: rhodes22-list <rhodes22-list at rhodes22.org>
Sent: Sun, Jan 19, 2020 9:29 pm
Subject: [Rhodes22-list] cabin wood treatment

I was curious what (if any) type of care people use for the wood in the
cabin.  On my boat, the cabin wood was dry, faded, and chipping in places so
I used a combination of Howard Orange Oil, Howard Resto-a-Finish (Walnut),
and Howard Feed-N-Wax that I saw recommended online.  You can see the before
and after photos below.  The improvement to the table top was dramatic. 
Looking back on this, I think it may been better to use a poly instead of
the wax for the last step.  I think I may try a wipe on poly at the end of
next season for more permanent protection.  

Some of the wood was delaminating underneath on the edges, so I cut some
thin oak to fit underneath on the edges and bolted that on.  I also used an
epoxy mix to coat the edge where it was chipping on top.  Not a fancy
solution but I think it will stop the damage.  While I was at it, I
reinforced some of the parts that take a lot of weight by screwing on some
thin boards underneath.  It seems a bit sturdier now.

Are there any recommendations from the group on how you treat the wood in
the cabin to keep it in good condition?

<http://rhodes-22.1065344.n5.nabble.com/file/t907/TableBeforeAfter.jpg> 
<http://rhodes-22.1065344.n5.nabble.com/file/t907/CabinAftBeforeAfter.jpg> 
<http://rhodes-22.1065344.n5.nabble.com/file/t907/CabinForewardBeforeAfter.jpg> 
<http://rhodes-22.1065344.n5.nabble.com/file/t907/WoodTreatmentProducts.jpg> 




--
Sent from: http://rhodes-22.1065344.n5.nabble.com/