Given the relative sizes of the line (FYI, it’s called the centerboard pennant) and the hose, I would not attempt to change out the hose with the pennant inside. Change out the empty hose, thread the pennant thru the hose, and finally attach the pennant to the centerboard.
A good hardware store has a huge selection of hoses. I changed out my centerboard pennant hose several years ago and I recall having several choices at my local Ace Hardware. It took longer to drive to the hardware store and back than the job itself required.
Roger Pihlaja
S/V Dynamic Equilibrium
Sent from my iPhone
> On Nov 8, 2019, at 7:17 PM, Allyn Baskerville <allynb at adsne.com> wrote:
>> ?I attached a photo to the email, but I guess the server stripped it off. Here is a link to what I sent:
>>https://1drv.ms/u/s!ApL2Pe-LKYIig0cINC3Nisn4lETt?e=9jRb5h>> As I said, there are two layers of tubes, and these are *very* stiff. I've raised the tube as high as it can go, so when I raise it further, the fiberglass cabin threshold raises up. I'm concerned about breaking fiberglass past this point. Goodness, I'll grab some of the cheap hose and give that a shot - I'll simply cut the old tube off with a knife.
>> ** I do have one question - there is a clamp at the top of the tube, and it is surrounded by fiberglass. There is no way of getting a screwdriver or nut driver in there apart from cutting out more fiberglass as far as I can tell. Is there any other option?
>> It's rained a lot this week. I drained 10 gallons out of the boat last week, and I'd say there is at least another gallon in it. I have 4 tubes of the 3M 4200 sealant - maybe I can get some of this resolved over the weekend.
> ________________________________
> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Goodness <spreadgoodnews at gmail.com>
> Sent: Sunday, November 3, 2019 9:05 PM
> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> Subject: Re: [Rhodes22-list] Unsure how to remove “hose” for centerboard line
>> Mine is a section of water hose between two through-hulls. The line runs through it and also the cockpit seat water drains into the centerboard trunk. The problem when i got my boat was someone had cut the hose too short and it was leaking into the cabin. (32 + points of water ingress.)
> Water hoses are all the wrong size for the through hulls. I found a best fit from dollar general cheap 1/2” hose. I heated it with a heat gun and managed to slip it all together with butyl rubber sealant on the barbs.
> The trick is getting the line through the hose while bending it enough to get it on the through hull barbs. A heat gun is needed to soften the hose but keep the line moving inside so it doesnt melt.
>> Bob (palatka)
>>> On Nov 3, 2019, at 9:23 PM, Graham Stewart <gstewart8 at cogeco.ca> wrote:
>>>> ?A picture would help as your arrangements might be a non-standard setup. The tube for my line is held in place with a hose clamp and is removed easily.
>>>> Graham Stewart
>> Agile 1976 Rhodes 22
>> Kingston Ontario
>>>>>>>> -----Original Message-----
>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Allyn Baskerville
>> Sent: Sunday, November 3, 2019 3:24 PM
>> To: rhodes22-list at rhodes22.org>> Subject: [Rhodes22-list] Unsure how to remove “hose” for centerboard line
>>>> I thought taking off the 52 or so screws was going to be the time consuming part, but I’ve spent more time trying to take off the hose assembly that goes around the centerboard line into the cabin. I’ve searched the forums, but I’m probably looking for the wrong part. I’m not sure what this is called, but I need to replace the line to the centerboard, and this is in the way. The hose looks double layered, and it’s very stiff. I recently bought this boat and removed 10 gallons of water from the bilge. It seems as if water has been leaking in here among a dozen other places. Can anyone provide me with ideas for taking the hose off? Thanks
>>>> -------------- next part --------------
>> A non-text attachment was scrubbed...
>> Name: IMG_0858.jpg
>> Type: image/jpeg
>> Size: 76642 bytes
>> Desc: IMG_0858.jpg
>> URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20191103/24a6c0e6/attachment.jpg>
>> -------------- next part --------------
>> An embedded and charset-unspecified text was scrubbed...
>> Name: ATT00001.txt
>> URL: <http://rhodes22.org/pipermail/rhodes22-list/attachments/20191103/24a6c0e6/attachment.txt>
>>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.
