________________________________
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of mweisner at ebsmed.com <mweisner at ebsmed.com>
Sent: Tuesday, November 5, 2019 4:20:05 PM
To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Rhodes 22 Boom Room
For those looking for Roger's photos, try these links:
http://rhodes22.org/rhodes/pics/bimini_room_1.jpghttp://rhodes22.org/rhodes/pics/bimini_room_2.jpghttp://rhodes22.org/rhodes/pics/biminitop3.jpg
lots more good stuff at:
http://rhodes22.org/rhodes/tech.html
Mike
s/v Wind Lass ('91)
Nissequogue River, NY
-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of ROGER
PIHLAJA
Sent: Tuesday, November 5, 2019 1:34 PM
To: Art Czerwonky <a_czerwonky at yahoo.com>; The Rhodes 22 Email List
<rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Rhodes 22 Boom Room
Art,
If you look on the photo website, you will see two photos of my boom room.
I think there is also a photo of my boat tied up to a dock at Kelly's Island
in Lake Erie, OH with just the boom room roof deployed. I made the boom
room myself by adding roof extensions and side curtains to my Bimini top.
When not in use, the front and rear roof extensions roll up under the Bimini
top and are secured there with straps and snaps. My boom room is designed
to be used in conjunction with the GBI OEM pop top enclosure, which came
with my boat. The front roof extension goes all the way forward to the mast
and covers the entire width of the deck all the way to the rail, port &
starboard, alongside of the pop top enclosure. This enables the front roof
extension to function as an awning over the sides of the pop top enclosure.
Having an awning allows the side windows to be left open for ventilation in
all but the most driving rain. The downside of this design is that to go
forward to the bow, you must go outside the rail and shuffle sideways along
the toe rail until you are forward of the mast. However, the boom room is
normally only used at anchor or a dock, so going outside the rail is not
usually a big deal.
This was, by far, the most difficult canvas fabrication project I have ever
attempted! It took me several months of sewing over a whole winter with
lots of visits to the boat to check fit. I'd never do it again! However,
you may be a more skilled canvas worker than I. I wish you good luck!
Roger Pihlaja
S/V Dynamic Equilibrium
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows
10
________________________________
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Art
Czerwonky via Rhodes22-list <rhodes22-list at rhodes22.org>
Sent: Tuesday, November 5, 2019 11:08:02 AM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Water tanks
Bravo Roger !
Anyone following your advice on how to get the best advantages of this
excellent craft will be well advised.
I am getting inquiries on the boomroom from would-be DIY makers. The design
looks simple, the difficulties enormous. Overall the R22 lends itself well
to mods into cruising plus.
Best to you,
Art
Sent from Yahoo Mail on Android
On Tue, Nov 5, 2019 at 9:07 AM, ROGER PIHLAJA<roger_pihlaja at msn.com>
wrote: Todd,
Go to the Defender Marine website
(<http://>www.defender.com<http://www.defender.com<http://www.defender.com<http://www
.defender.com>>) (800-628-8225) and take a look at the todd M/N 94-1627WH,
Defender C/N 503130 water tank. This tank has a capacity of 15 gal and the
dimensions are 25" L X 11" W X 15" D. The MOC is FDA & USCG certified
polyethylene. The plumbing and vent connections are molded in and are all
female NPT. The same vender can supply the various plumbing fittings, hose,
clamps, and valves to complete the job.
S/V Dynamic Equilibrium came with water tank mounting beds molded into the
interior of the hull. On your boat, look behind (i.e. aft of) the
floatation foam under the V-berth and in front of the V-berth bulkhead. You
should see an empty space sized to fit the above specified tank. The molded
in mounting beds will provide good support for the tank up in the deep V
part of the bow . My water tank mounting beds have slots in them. These
slots allow a nylon outboard gas tank strap to be rigged around the water
tank. The water tank is held in place by the floatation foam in front, the
V-berth bulkhead behind, and the mounting beds + strap prevent side-to-side
and upward movement. But, this mount still allows the water tank to be
removed if necessary.
Easy peasy! I don't know why anyone would want to go to all the trouble and
expense of a permanently mounted water tank when this option is available.
Roger Pihlaja
S/V Dynamic Equilibrium
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows
10
________________________________
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Todd
Tavares <tavares0947 at gmail.com>
Sent: Tuesday, November 5, 2019 7:09:28 AM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Water tanks
Has anyone built, or considered building a permanent integral water tank?
(Peter?)
I have been watching several YouTube videos by atomvoyager and he always
builds integral tanks and coats the inside of the tank with food grade
epoxy. It may be a worthy project as my R 22 does not have a water tank at
all. But the epoxy is quite expensive.
https://youtu.be/bUiV90sPMbUhttp://www.sscoatings.net/brewcoat.htm
Todd T.
tavares0947 at gmail.com
On Mon, Nov 4, 2019, 8:31 PM Kathy Leone <kathy.leone at qltcls.com> wrote:
> Hello Rhodies,
>> After many years of sailing on Rhodes 22 sailboats, we are selling our
> 2012. She is in excellent condition with the following items worth
> mentioning:
> (1) Navy blue hull
> (2) 175 Genoa
> (3) 9.9 Yahama engine with tiller hookup. This engine is from the
> 2004 boat we purchased. We have been utilizing it on our 2012 and
> love how it works. Our mechanic at the marina recently gave the
> engine an overhaul and she is purring. This included a brand new lower
unit.
> (4) Galvanized trailer
> (5) Safety rails
>> We are located on Long Beach Island in New Jersey. We are asking
> $29,500 per a discussion with Stan and will consider any reasonable offer.
>> Thank you and Happy Sailing,
>> Kathy
> S/V REVERIE
> 2012 R22
> Long Beach Township, NJ
>>>>>> -------------- next part -------------- A non-text attachment was
> scrubbed...
> Name: Rhodes1.jpg
> Type: image/jpeg
> Size: 100170 bytes
> Desc: Rhodes1.jpg
> URL: <
>http://rhodes22.org/pipermail/rhodes22-list/attachments/20191105/942e0> 04c/attachment.jpg
> >
> -------------- next part -------------- A non-text attachment was
> scrubbed...
> Name: Rhodes2.jpg
> Type: image/jpeg
> Size: 116200 bytes
> Desc: Rhodes2.jpg
> URL: <
>http://rhodes22.org/pipermail/rhodes22-list/attachments/20191105/942e0> 04c/attachment-0001.jpg
> >
> -------------- next part -------------- A non-text attachment was
> scrubbed...
> Name: Rhodes3.jpg
> Type: image/jpeg
> Size: 104467 bytes
> Desc: Rhodes3.jpg
> URL: <
>http://rhodes22.org/pipermail/rhodes22-list/attachments/20191105/942e0> 04c/attachment-0002.jpg
> >
> -------------- next part -------------- A non-text attachment was
> scrubbed...
> Name: Rhodes4.jpg
> Type: image/jpeg
> Size: 86589 bytes
> Desc: Rhodes4.jpg
> URL: <
>http://rhodes22.org/pipermail/rhodes22-list/attachments/20191105/942e0> 04c/attachment-0003.jpg
> >
> -------------- next part -------------- A non-text attachment was
> scrubbed...
> Name: Rhodes5.jpg
> Type: image/jpeg
> Size: 85458 bytes
> Desc: Rhodes5.jpg
> URL: <
>http://rhodes22.org/pipermail/rhodes22-list/attachments/20191105/942e0> 04c/attachment-0004.jpg
> >
> -------------- next part -------------- A non-text attachment was
> scrubbed...
> Name: Rhodes6.jpg
> Type: image/jpeg
> Size: 107714 bytes
> Desc: Rhodes6.jpg
> URL: <
>http://rhodes22.org/pipermail/rhodes22-list/attachments/20191105/942e0> 04c/attachment-0005.jpg
> >
>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.
