Hey Allyn,
As you see there are lots of experienced Rhodies ready to give you a wide
range of information on most subjects. Another advantage to sailing a
Rhodes. If you are interested in cruising the PNW or the sea of Cortez you
can email me and I can send you some journals on sailing those areas.
Again, welcome to the list and the brother and sisterhood of the Rhodes 22.
Chris Geankoplis
S/V ENOSIS

On Sun, 20 Oct 2019 at 20:21, Allyn Baskerville <allynb at adsne.com> wrote:

> It's probably not good etiquette to ask several questions at once, but
> I'll see how far I get. I just brought home a 2001 Rhodes 22, and I
> purchased it as sight-unseen, but I figured for the price it was worth it.
> There were a few things misrepresented, but I'm pleased overall.
>
> 1) The solar panels are no good. They are cracked, and I'd like more
> capacity. Has anyone upgraded to 100W solar?
> 2) The water tank has been replaced with a blue storage container like
> what you'd get from Walmart. The lid is screwed on with 3 dozen or more
> screws, but I don't want to take it apart. That needs to go. What is an
> acceptable replacement?
> 3) I'm going to be spending an extended time cruising next summer, and I
> need to install a bilge pump. The most logical place I can find is under
> the battery next to the head. I'm not sure how to get the water out, but
> the sink seems reasonable. I'm not able to see how to get the drain line to
> the sink since no floor panels life out.
> 4) The previous owner tied a spreader down when he moved it. It doesn't
> look bent, but one side seems considerably looser than the other. I don't
> see how to tighten these down. Any suggestions?
> 5) I'd like to replace the water line to the sink. Again, I don't see a
> way to access it to do this. Any help?
> 6) I don't believe the boat has been sailed since 2011. The genoa has had
> the edge exposed to the sunlight since then, and it's faded. I'm expecting
> it to be weak. Are there suggestions for a source for Rhodes sails?
> 7) I pull loose the power distribution panel, and the anchor light wires
> are cut about 5" from where they are screwed on. I don't see the cut end
> anywhere behind the panel. Any suggestions as to how to get access to the
> wires? Do I have to drop the headliner?
>
> Thanks - Baker
> 8) Is there a source for the mast stepper or plans for a DIY?
>
>