Larry, if you're referring to the chartplotter, here's my installation. It is mounted on the starboard side of the companionway . It is a double bulkhead so the opening doesnt compromise the cabin. I drilled a 3/8" hole from the cabin side to accomodate the cable to the transducer.Sent via the Samsung Galaxy S22 5G, an AT&T 5G smartphone

20220717_094440.jpg

-------- Original message --------From: Larry Gioia via Rhodes22-list <rhodes22-list at rhodes22.org> Date: 7/26/22  1:18 AM  (GMT-05:00) To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] In-hull transducer? A picture would be great. Where has everyone installed the readout?     Larry> On Jul 25, 2022, at 10:54 PM, gstewart.gm at gmail.com wrote:> > I put mine in the lazarette between the bulkhead and the drain. I attached a> short piece of pvc tube with 3M 4200 sealant and then installed the> transducer in the tube with DAB sealant so it can be removed easily. I> wanted to protect the transducer from shifting materials in the lazarette> and also have a system that could be relocated f necessary. This seems to> work well. If interested I can send a picture.> > -----Original Message-----> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of Joe> Dempsey> Sent: Monday, July 25, 2022 7:23 PM> To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>> Subject: Re: [Rhodes22-list] In-hull transducer?> > Bob,> Mine is installed in the lazzarette on the centerline just behind the> cockpit drain pipe. I would not epoxy in case you have to remove/replace it.> I used clear silicone. Works fine.> > Joe Dempsey> SV Respite> Deltaville, VA> > -----Original Message-----> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of John> Keyser> Sent: Monday, July 25, 2022 4:08 PM> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>> Subject: Re: [Rhodes22-list] In-hull transducer?> > Hi Bob,> I put one in my boat at the same approximate place. No thru-hull> installation. Just epoxied it to the inside of the hull following the> manufacturers instructions. Works fine - no issues.> Good luck!> John Keyser> "Deci-Belle"> Philadelphia, Pa> ________________________________> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Bob> Garrant <bgarrant at gmail.com>> Sent: Monday, July 25, 2022 2:23 PM> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>> Subject: [Rhodes22-list] In-hull transducer?> > Hi folks,> I am installing an in-hull transducer.> I'm trying to figure out where to locate it. Thinking about placing it below> the cabin floor just offset from the centerboard sleeve.> Wondering if anyone in the group has installed an in-hill transducer and how> it was done.> Thanks very much> Bob Garrant> Sail la Vie> Kent Island, MD> >