Same place Stan put mine on my '86.

Lee
1999 Rhodes22. AT EASE
Claytor Lake, VA

On Mon, Jul 25, 2022, 10:54 PM <gstewart.gm at gmail.com> wrote:

> I put mine in the lazarette between the bulkhead and the drain. I attached
> a
> short piece of pvc tube with 3M 4200 sealant and then installed the
> transducer in the tube with DAB sealant so it can be removed easily. I
> wanted to protect the transducer from shifting materials in the lazarette
> and also have a system that could be relocated f necessary. This seems to
> work well. If interested I can send a picture.
>
> -----Original Message-----
> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of Joe
> Dempsey
> Sent: Monday, July 25, 2022 7:23 PM
> To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>
> Subject: Re: [Rhodes22-list] In-hull transducer?
>
> Bob,
> Mine is installed in the lazzarette on the centerline just behind the
> cockpit drain pipe. I would not epoxy in case you have to remove/replace
> it.
> I used clear silicone. Works fine.
>
> Joe Dempsey
> SV Respite
> Deltaville, VA
>
> -----Original Message-----
> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of John
> Keyser
> Sent: Monday, July 25, 2022 4:08 PM
> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> Subject: Re: [Rhodes22-list] In-hull transducer?
>
> Hi Bob,
> I put one in my boat at the same approximate place. No thru-hull
> installation. Just epoxied it to the inside of the hull following the
> manufacturers instructions. Works fine - no issues.
> Good luck!
> John Keyser
> "Deci-Belle"
> Philadelphia, Pa
> ________________________________
> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of Bob
> Garrant <bgarrant at gmail.com>
> Sent: Monday, July 25, 2022 2:23 PM
> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
> Subject: [Rhodes22-list] In-hull transducer?
>
> Hi folks,
> I am installing an in-hull transducer.
> I'm trying to figure out where to locate it. Thinking about placing it
> below
> the cabin floor just offset from the centerboard sleeve.
> Wondering if anyone in the group has installed an in-hill transducer and
> how
> it was done.
> Thanks very much
> Bob Garrant
> Sail la Vie
> Kent Island, MD
>
>
>